BMS Link System: Where Portability Meets Integration

You’ve seen it before—the clipboard hanging by the door, the laminated checklist, the operator who closes the dampers, confirms the room is sealed, starts the cycle, watches the clock, and walks in with a handheld meter to decide whether the space is ready. It works. It has worked for years. And it introduces variation into every single cycle.

That variation shows up where it matters most: in your environmental monitoring trends. Not always as a failure, but as noise—small differences between operators, between shifts, between Tuesday afternoon and Sunday at 3 a.m. Enough noise, and the trends stop telling you anything useful.

The BMS Link System™ was built to close the gap between portable biodecontamination equipment and the building management system that already runs the rest of your facility.

Closing the Gap

Until now, facilities that wanted decontamination to communicate with their building management system had two options. They could run a fully custom integration project—months of engineering, custom hardware, significant cost—or they could keep doing it manually.

The BMS Link System™ fills the space in between. It is a pre-defined, standardized set of components that creates a quick-connect handshake between your CURIS 3 units, an H₂O₂ ppm sensor, and your BMS. Deploy a system per room—one facility currently in progress is covering more than ten—or, because CURIS 3 units can be disconnected, move them to the next wall panel as soon as the Pulse™ phase is complete.

Built on years of custom integration work at pharmaceutical, biotech, and biosafety facilities, the BMS Link System™ takes what CURIS learned and packages it as a defined-scope product for seamless installation.

What Changes When the Building and the Cycle Talk to Each Other

Reentry becomes a measurement, not a countdown. Your reentry timer was set during validation with a margin built in—rounded up, because releasing a space early is unacceptable and releasing it late is merely inconvenient. That margin gets applied to every cycle, every night, for the life of the room. The BMS Link System™ monitors hydrogen peroxide concentration throughout the cycle and signals your BMS when your predetermined reentry threshold has actually been reached. The room comes back when it is ready. Nobody stands at the door with a handheld meter.
The cycle runs the same way every time. Pre-programmed cycles mean operators select the validated cycle for that room, not configure it. Touchscreen operation at the wall panel—no laptop, no manual, no vendor on the phone. The system is designed to be run by the people who work in the space, not by the person who commissioned it.
Documentation generates itself. Cycle records are created automatically. Your quality and risk management teams get the data without anyone transcribing it. For cGMP and EU GMP Annex 1 environments, that means less transcription risk and a cleaner audit trail.

Your Equipment Stays Available

This detail changes the math for many facilities. The BMS Link System™ does not consume your CURIS 3 units. They connect at a wall panel when a cycle runs and disconnect when it is done—available for another room, another building, or a response the schedule did not plan for.

You get the repeatability of an integrated cycle without permanently dedicating capital equipment to one space. That is what “where portability meets integration” means in practice.

Particulate Cleaning Stays Foundational

Integrated vaporized hydrogen peroxide (VPHP) biodecontamination enhances, but does not replace, your cleaning program. The BMS Link System™ makes the VPHP step repeatable, documented, and independent of who performed it. Environmental monitoring validates routine cycles. Biological indicators support sporicidal efficacy claims during validation, periodic requalification, and at the cadence of risk management.

See How It Fits Your Space

Send your space volume and what your building management system controls today. A CURIS integration engineer will confirm whether the BMS Link System™ fits your facility—and tell you plainly if it does not.

Learn more about the CURIS BMS Link System™ or call 1-800-928-8708.

BMS Link System: Where Portability Meets Integration